camera standby
Set or change camera standby status.
When sending the command to a host device, you must specify the camera input.
Synopsis (host
device)
camera
<input>
standby { get | off | on | toggle }
Synopsis (camera) camera standby { get | off | on | toggle }
Options
<input>
Specifies the camera to control.
EasyIP Decoder: 1 to 4.
EasyIP Mixer: 2 to 5.
get
Returns the camera's current standby state.
off
Brings the camera out of standby (sleep) mode.
on
Stops video and puts the camera in standby mode.
toggle
Changes the camera's standby state - if it was not
in standby mode, it enters standby; if it was in
standby mode, it "wakes up."
Examples
>
camera standby off
OK
>
(Sent to the camera) Brings the camera out of standby mode.
>
camera 3 standby get
standby:
on
OK
>
(Sent to the host device) Returns the current standby state of the specified camera.
119
Complete Manual for EasyIP Systems
