User Manual
12
Set Input level (High, Low) to make it work!
iii. Smart IR
Set 0~6 to adjust the curve of brightness to prevent
overexposure/underexposure of image blocks.
iv. IR CUT Output
Via GPIO 3, output high/low level for IR-CUT use.
Mode:
Ext
When reaching assigned brightness, change to BW.
i. Color
burst
On/Off Color burst
ii. Delay control
Delay time for changing Day/Night mode (0~255
）
iii. Day
→
Night
Set the start point from Color mode to BW mode.
Day->Night value must be greater than Night->Day value.
iv. Night
→
Day
Set the recovery point from BW mode to Color mode.
Day->Night value must be greater than Night->Day value.
v. IR CUT Output
By GPIO 3, output high/low level for IR-CUT use. Mode
(High/Low/Off)
