22
a)
Enter: Exit from On Screen Display.
b)
Up /
Down: Change item Selection.
c)
Right /
Left: Select Each mode, Each Value.
◆
CAMERA ID
Camera ID. 0~255
◆
BAUDRATE
(remark 7)
The Communication rate is set.
2400/4800/9600/19200bps
◆
PROTOCOL
(remark 8)
Select Protocol. PELCO-P/PELCO-D
◆
SAVE PROTOCOL
The above(CAMERA-ID,BAUDRATE and PROTOCOL) item are renewed
though changes.
The change becomes effective by SAVE. PROTOCOL.
NOT USE (ID , BAUDRATE and PROTOCOL) are not changed.
NG
→
ENT Press ENTER,(ID , BAUDRATE and PROTOCOL) change are CANCEL.
OK
→
ENT Press ENTER,(ID , BAUDRATE and PROTOCOL) change are Available.
◆
ID DISPLAY
Camera-ID display on normal screen.
OFF/ON
remark 7.
The communication rate and the baud rate are the same for this camera.
remark 8.
It is likely not to operate according to the product though Protocol is verified
made by the Pelco company Pelco-P/D. This VB doesn't support RS485 Serial
communication.
e. LANGUAGE
Language setup.
f. INITIAL
The setting of Camera is returned to Default.
DEFAULT There is no change in the setting of Camera.
USER There is any changes in the setting of Camera.
OK
→
ENT It returns to Default setting when Enter-Switch is pushed.
