Vacon 500X, User Manual

Page: 59 / 124

24-hour s358 (0)40 837 1150 • Email: vacon@vacon.com
using macro mode and getting a quick start vacon
z
58
6
Para. # Parameter Name Default See Page
203 Stop Key Remote Coast 66
204 Ref Select Vin1 67
205 Vin1 Config 0-10 V 67
206 Vin1 Offset 0.00% 67
207 Vin1 Span 100.00% 67
208 Cin Config 0-20 mA 50 67
209 Cin Offset 0.0% 68
210 Cin Span 100.0% 68
211 Vin2 Config 0-10 V 68
212 Vin2 Offset 0.00% 68
213 Vin2 Span 100.00% 68
401 Ramp Select ART-Strt/RS 71
406 DC Inject Config DC at Stop 72
501 V/Hz Select Pump Fxd 75
504 Skip Freq Band 0.2 Hz 76
505 Skip Freq 1 0.0 Hz 76
608 Restart Number 0 80
609 Restart Delay 60 sec 80
702 Imet Config Current Out 82
703 Imet Span 100.0% 82
704 Imet Offset 0.0% 82
721 DI1 Configure Preset 1 84
722 DI2 Configure Preset 2 84
723 DI3 Configure Preset 3 84
724 DI4 Configure Ref Switch 84
725 DI5 Configure PI Enable 84
803 PWM Frequency 16.0 kHz 88
804 Display Mode Output Freq 88
850 PI Configure No PI 90
851 PI Feedback Vin1 90
852 PI Prop Gain 0 90
853 PI Int Gain 0 90
854 PI Feed Gain 1000 90
857 PI High Corr 100.00 90
858 PI Low Corr 0.00% 90
Table 5: Pump with PI Application Macro
(Core Factory Application from Table 1, plus the following parameters)
Para. # Parameter Name Default See Page
501 V/Hz Select Vector 75
509 Rated Mtr Volt Model dependent 76
510 Rated Mtr FLA ND rating 76
Table 6: Vector Application Macro
(Core Factory Application from Table 1, plus the following parameters)