7
DRY VACUUM OPERATION
DRY VACUUMING
WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION
ENTITLED “IMPORTANT SAFETY INSTRUCTIONS”. DO NOT VACUUM IN AREAS WITH
FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE
GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT
TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL, OR AEROSOL SPRAYS.
EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN, OR
GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR DUST,
DO NOT VACUUM TOXIC MATERIALS.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. For improved dust filtration, fit the dust bag flange onto the inlet port, taking care not to damage
the bag (Fig. 2).
3. Place the pre-filter onto the rim of the collection tank. Make sure the edge of the filter fits snugly
along the edge of the collection tank (Fig. 3).
4. Place the power head back on the collection tank, and secure it in place using the latches
(Fig. 4).
OPERATING INSTRUCTIONS: DRY VACUUMING
5. Insert the locking end of the hose into the vacuum port on the collection tank and turn clockwise
to lock into place.
6. Choose the desired attachment and insert onto the end of the hose or extension wand (Fig. 5).
7. The air flow regulation on the hose handle allows you to adjust the amount of vacuum suction.
For best cleaning results, fully close the air flow regulation (Fig. 6).
NOTE:
Open the air flow regulation for lightweight rugs or thick carpets. Close the air flow
regulation suction for upholstery, hard floor or low pile carpets.
WARNING:
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE
SURE THE PLUG IS DISCONNECTED BEFORE CHANGING THE FILTERS.
1
2
3
4
5
6
7
8
10
9
﹢
－
CAUTION:
DO NOT VACUUM DRYWALL DUST, FIREPLACE SOOT, OR ASH WITH
THIS VACUUM. THIS IS A VERY FINE DUST WHICH WILL NOT BE CAPTURED BY THE
FILTER AND WILL CAUSE DAMAGE TO MOTOR.
CAUTION:
THIS VACUUM IS INTENDED FOR DRY PICK-UP ONLY.
Summary of Contents for VZA306P 0201
Page 12: ...12 EXPLODED VIEW ...
