-15-
IMPORTANT:
The filter, foam and basket must be completely dry before reuse.
6) Insert the clean and dry foam along with the filter into the basket. Fit the basket
into the dust cup and reconnect the dust cup to the hand vacuum.
3) Lift the brush roll out of the housing. Clean off debris and anything wrapped
around the brush. Use a pair of scissors to remove threads, etc.
4) Place the brush roll back into the housing by aligning the round end to the
powerhead
first, then inserting the square end correctly into place.
WARNING
Do not operate vacuum cleaner without filter installed.
Cleaning the Motorized Powerhead & Blockages
The brush roll may accumulate debris such as strings, hair and fibers. This type
of debris can wrap around the brush and diminish its ability to clean effectively.
To Remove Brush Roll for Manual Cleaning:
1) Make sure the vacuum cleaner is OFF then remove the hand vacuum and set
aside.
2) Turn unit over to access the brush roll. As shown below, slide tab down to unlock,
then rotate the lock up and out of the way.
Note:
Use warm water when cleaning the foam.
1
2
