Vacmaster VQ1220PF, Operator'S Manual

Page: 11 / 33

11
WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION,
ENTITLED ‘SAFETY INSTRUCTIONS & WARNINGS’. DO NOT VACUUM IN
AREAS WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR.
FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO;
LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE,
ALCOHOL OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE BUT ARE NOT
LIMITED TO; COAL, MAGNESIUM, GRAIN OR GUN POWDER. TO REDUCE THE
RISK OF HEALTH HAZARDS FROM VAPORS OR DUST, DO NOT VACUUM TOXIC
MATERIALS.WARNING: DO NOT PLUG IN POWER CORD TO POWER OUTLET,
MAKE SURE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY
VAC
5.1. Verify that the power cord is disconnected from the outlet. Verify that the container is
clean and free of dust and dirt. ( fi g. 1)
5.2. Remove dust fi lter, then carefully install the foam fi lter over the fi lter cage and place
the power head back on the container. ( fi g. 2)
DO NOT USE THE DUST FILTER FOR LIQUID VACUUMING. OPERATING
INSTRUCTIONS – WET VACUUMING
5.3. Fit the desired nozzle to the vacuum hose. ( fi g. 3)
5.4. Verify that the switch is in the ‘O’ OFF position before plugging the power cord into
the outlet.( fi g. 4)
5.5. Turn the motor on by fl ipping the switch to the ‘I’ ON position.( fi g. 5)
5.6. After use, empty the tank and dry.
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle
completely in the liquid; leave a gap at the tip of the nozzle opening to allow air in fl ow. The
machine is fi tted with a fl oat valve that stops the suction action when the container
reaches its maximum capacity. You will notice an increase in motor speed. When this
happens, turn off the machine, disconnect from power supply, and drain the liquid into a
suitable receptacle or drain. To continue
vacuuming, re
fi t the container with the drain cap. After wet vacuuming, turn the machine
off and remove plug from power supply. Empty the container, clean and dry the inside
LIQUID VACUUM OPERATION