6
GENERAL ASSEMBLY INSTRUCTIONS
WARNING: DO NOT PLUG POWER CORD INTO POWER OUTLET. MAKE SURE PLUG IS
DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VACUUM.
1. Verify that the power cord is disconnected from the outlet. (Fig. 1)
2. Undo the latches. (Fig. 2)
3. Lift the power head off the collection tank. (Fig. 3)
4. Remove the contents from inside the tank; make sure you have all contents as listed in the
carton contents list on page 5. (Fig. 4)
5. Turn the collection tank upside down and insert the two casters into the sockets on the bottom
of the base. Apply pressure until casters snap into place. (Fig. 5)
6. Insert the wheel axle into the rear wheel housing on the vacuum base. Insert a washer onto
the axle followed by a rear wheel and insert another washer. Insert the locking pin into the
hole on the end of the axle to lock the wheel. Snap the hub cap onto the wheel. Repeat the
same steps at the other end of the axle. (Fig. 6)
7. Position the hose storage rack as illustrated. Insert one side of the rack into the channel,
making sure it is secured in place. Squeeze in the other end and insert it into the
corresponding channel, making sure it is secured. (Fig. 7)
8. Insert the push/pull handle into the handle socket mounted on the tank body. Push down until
the lock pin clicks in place. (Fig. 8)
9. Your vacuum comes ready for dry vacuum cleaning. For filter installation instructions, see
page 11. Optional: For improved dust filtration, fit a dust collection bag onto the inlet port,
taking care not to damage the bag. Dust bag sold separately. (Fig. 9)
A Philips head screwdriver driver is required.
1
2
1
2
3
4
5
6
9
7
8
10
11
12
13
14
