9
Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position, carefully remove foam
sleeve fi lter. (fi g. 3)
2. Use a mild soap and water solution to wash foam sleeve fi lter and rinse with clean
water. (fig. 4)
3. Allow fi lter to air dry before installing and using again.
2
1
4
3
5
I
NSTALLING & CLEANING HEPA FILTER
Installing HEPA FILTER
1. Verify that the power cord is disconnected from the outlet. (fi g.1)
2. Unlock the fi lter door by lifting the lock tab UP to the unlocked position and pull
the door out. (fi g. 2 & 3)
3. Remove the HEPA fi lter cartridge from the vacuum. (fi g.4)
Cleaning HEPA Filter
4. Clean fi lter by brushing dirt off. For optimal performance a new fi lter is
recommended. (fi g.5)
5. Install the cleaned or new fi lter into place. (fi g. 6)
6. Insert the fi lter door tabs into the upper slots and lock the fi lter door into place.
(fi g. 7 & 8)
7
8
6
2
1
4
3
5
T
ROUBLESHOOTING
Symptom
Possible Causes
Corrective Action
Vacuum will not
operate
1) No power supply.
1) Check power supply – cord,
breakers, fuses.
2) Faulty power cord.
2) Unplug and check the
power cord. If damaged,
have it repaired by a
professional.
3) Container full.
3) Empty container.
Dust comes out
from motor cover.
1) The PET cartridge
fi lter or collection bag
is missing or damaged.
1) Attach or replace PET
cartridge fi lter or collection
bag.
Reduced
effi ciency and
motor/speed
vibration.
1) There is a blockage in
the nozzle or hose,
or the container inlet.
Or dust fi lter blocked
by fi ne dust.
1) Check nozzle, hose and
container inlets for
blockage. Take off the fi lter
and clean it. Or install new
cartridge fi lter.
