ENGLISH
- 49 -
12 - ACCESSING THE CONTROL UNIT
SETTINGS
1.
Press and hold the
OK
key until the display shows the menu
desired
2.
Release the
OK
key: the display will show the first item in the
sub-menu
-PrG
Programming the control unit (chapter 17)
-Cnt
Cycle counter (chapter 16)
-SEt
Auto-learning end-stop (chapter 15)
-dEF
Loading the default parameters (chapter 13)
m
WARNING: in case no operation is carried out for
more than one minute, the control unit exits from the
programming mode without saving any of your setups and
changes, which will get lost.
13 - LOADING THE DEFAULT
PARAMETERS
If necessary, it is possible to restore all parameters to their
standard or default values (see the final summary table).
m
PLEASE NOTE: This procedure results in the loss of all
customised parameters.
1.
Press and hold the
OK
key until the display shows
-dEF
2.
Release the
OK
key: the display shows
ESC
(only press the
OK
key if it is desired to exit this menu)
3.
Press the
i
key: the display shows
dEF
4.
Press the
OK
key: the display shows
no
5.
Press the
i
key: the display shows
Si
6.
Press the
OK
key: all parameters are overwritten with their
default values (see Chapter 17), the control units exits
programming mode and the display shows the control panel.
-PrG
d i r
-Cnt
tot
-SEt
ESC
-
-
-
-
2’’
4’’
6’’
-dEF
ESC
8’’
10’’
dEF.
ESC
-dEF
Si
no
