V2 ELETTRONICA City2 Instructions Manual Download Page 20

Page: 20 / 72

CONTROL PANEL

Perform the electrical connections to the terminal
board, then supply power to the system: the unit will
check the operation status of the display, by turning all
the segments on for 1,5 seconds

8.8.8.8

; after this,

the display will show the firmware version for 1,5
seconds, for instance

Pr 2.0

Now, the display will show a control panel:

The control panel represents the physical status of the
terminal board contacts and of the program mode keys:
if the upper vertical segment is on, the contact is clo-
sed; if the lower vertical segment is on, the contact is
open (the above picture shows an instance where the
inputs START, START P, PHOTO1, PHOTO2, and STOP
have all been correctly connected).

PROGRAMMING

The

City2

unit presents a programming structure with

menus, each of which corresponds to a function in the
unit (function menu) or to a working time setting (time
menu).
Time menus allow adjusting the unit working times
(e.g.: leaf opening or closing time, locking time, preflas-
hing time, etc.).

Time programming will be carried out through an algo-
rithm, which speeds up the operations by automatically
matching the adjustment pitch according to the current
set up value:
•

from 0 seconds to 1 minute the adjustment pitch is

equal to 0,5 second:

•

from 1 minute to 10 minutes the adjustment pitch

is equal to 5 seconds:

•

for more than 10 minutes the adjustment pitch is

equal to 30 seconds:

On the other side, the function menu are used to activa-
te the required functions (e.g. timed lights, PHOTO1
active as a travelling edge, PHOTO2 inactive, etc.).

FUNCTION OF KEYS
MENU, UP, DOWN

To activate the program mode, proceed as follows.
•

After powering the unit, the display should show the
control panel (therefore, check that the connections
made are correct).

•

Press and hold key MENU until the display
shows

dEF

Now your programming has been activated.
WARNING: in case no operation is carried out for more
than one minute, the gearcase exits from the program-
ming mode without saving any of your setups and chan-
ges, which will get lost.
You will have to exit from the programming mode –
through the

FinE

menu – to store all set up data (even

in case you choose the default data).

When the program mode function is activated, press
key UP or DOWN to select the menus, thus performing a
forward or backward shift (for a fast shift, press and
hold).

Press key MENU to access the settings in order to
change them through keys UP and DOWN.

•

Pressing the UP key, the menu functions can be
scrolled from below.

•

Pressing the DOWN key, the menu functions can be
scrolled from above.

•

Pressing the MENU key, the settings to be changed
can be accessed and selected by pressing again.

ATTENTION:

when the program mode function is not

activated, pressing of the UP key corresponds to the
START command, pressing of the DOWN key corre-
sponds to the PEDESTRIAN START command: this way,
the service engineer is enabled to perform the test and
the set-up.

The

City2

unit can be set up in two different program

modes: DEFAULT PROGRAM MODE or CUSTOM
PROGRAM MODE.

In the following pages you can find a functions diagram
with information concerning

City2

For the use of the function chart proceed as follow:

•

Press DOWN key to flow the chart from the top to
the bottom. The functions

dEF

t.AP1

t.AP2