V-ZUG DIAS 10, Operating Instructions Manual

Page: 12 / 24

4 Care and maintenance
▸ Touch the button.
– The after-running time switches on.
– The button for the corresponding power level illuminates and the LED for the
button flashes for 15 minutes.
▸ Touch the button again.
– The LEDs no longer illuminate.
– The after-running time switches off before time.
4 Care and maintenance
4.1 Cleaning the housing
Take care that no water gets into the housing of the appliance! If water gets into
the housing, it can cause damage.
Do not use abrasive cleaners, scouring pads, steel wool, etc. for cleaning, as the
surface could otherwise be damaged.
Remove the screw fuse or switch off the circuit breaker.
Cleaning the outside/inside
▸ With the appliance switched off, hold the button depressed for five seconds.
– Wipe protection is activated, all the buttons flash in sequence from left to right.
▸ Clean the outside with a slightly damp cloth and neutral cleaning agent, then wipe dry.
Grease and condensate water can build up on the inside around the metal grease filters.
▸ Clean the inside with a slightly damp cloth and neutral cleaning agent, then wipe dry.
▸ After cleaning, depress the
button for five seconds.
– Wipe protection is deactivated.
4.2 Removing the metal grease filters and air outlet grilles
Removing the lower metal grease filters
▸ Pull handle 1 down and take the metal
grease filters 2 down and out.
1
2
12