V-ZUG Adorina V600, Information For Use

Page: 51 / 60

Troubleshooting
en
51
Fault Cause and troubleshooting
Excessive formation of
foam occurs. Detergent or appliance care product used causes ex-
cessive foaming.
▶
Change the brand of detergent.
Special salt refill indic-
ator lights up. Insufficient special salt.
▶
Add Special salt → Page 24 .
Sensor does not detect special salt tablets.
▶
Do not use special salt tablets.
Refill indicator for spe-
cial salt does not light
up. Water softening system is switched off.
▶
Set the water softening system.
→
"Setting the water softening system", Page 24
Refill indicator for
rinse aid lights up. Insufficient rinse aid.
1.
Add Rinse aid → Page 26 .
2.
Set the amount of rinse aid to be dispensed.
→
"Setting the amount of rinse aid", Page 26
Refill indicator for
rinse aid does not
light up. Rinse aid system is switched off.
▶
Set the amount of rinse aid to be dispensed.
→
"Setting the amount of rinse aid", Page 26
Display flashes. Appliance door is not closed properly.
▶
Close the appliance door.
‒
Arrange the tableware so that no parts project
beyond the basket and prevent the appliance
door from closing properly.
Water is left in the ap-
pliance at the end of
the programme. Filter system or area under the filters is blocked.
1.
Clean the Filters → Page 38 .
2.
Clean the Wastewater pump → Page 54 .
Programme has not yet ended.
▶
Wait until the programme ends or cancel the pro-
gramme with
Reset
.
▶
→ "Terminate programme", Page 33
Appliance cannot be
switched on or oper-
ated. Appliance functions have failed.
1.
Pull out the mains plug or switch off the fuse.
2.
Wait at least 2 minutes.
3.
Connect the appliance to the power supply.
4.
Switch the appliance on.
Appliance does not
start. The mains fuse has tripped.
▶
Check the relevant fuse.
Mains cable is not inserted.
1.
Check whether the socket works.