V-ZUG AdoraWash V4000 OptiDos, Operating Instructions Manual

Page: 50 / 64

14 Trouble-shooting
14.2 Other possible problems
Problem Possible cause Solution
The washing has
not been spun or
has been spun in-
sufficiently. ▪ The spin speed set is
too low. ▸ Increase the spin speed for the next
wash cycle (see page 36).
▪ Large unbalanced load
in the washing drum ▸ Wash large and small items to-
gether.
▪ «Steam anti-crease»
was selected and the
appliance was not
standing level. ▸ Optimize appliance set-up according
to installation instructions.
The appliance vi-
brates heavily
when spinning. ▪ The transport lock has
not been removed. ▸ Remove transport lock.
▪ The feet of the appli-
ance are not properly
adjusted. ▸ Set appliance feet so that the appli-
ance stands level.
▪ The load could not be
optimally balanced in
the washing drum. ▸ Wash large and small items to-
gether.
At the end of the
programme, the
appliance door
cannot be opened
with the
but-
ton.
▪ The appliance door is
stuck. ▸ Press hard against the lock area of
the appliance door (i.e. front edge of
appliance door).
▸ Touch the button again.
▪ An interruption in the
power supply. ▸ Use the emergency door
release (see page 46).
Water sounds
after programme
has finished when
washing drum is
turned by hand. ▪ The vanes are filled with
water to compensate
the unbalanced load. ▸ The water is automatically pumped
off. No action is necessary.
Traces of condi-
tioner or water in
fabric conditioner
compartment. ▪ Siphon in fabric condi-
tioner compartment is
missing or not inserted
correctly. ▸ Insert the siphon correctly (see page
44).
▪ Siphon or suction tube
is clogged. ▸ Clean siphon and suction tube (see
page 44).
50