• Turn the LUX knob clockwise on the maxi-
mum (sun). Turn the SENS knob clockwise
on the maximum (+). Turn the TIME knob
anti-clockwise on the minimum (10s).
• When you switch on the power, the light
will be on at once. And 10sec±3sec later
the light will be off automatically. Then if
the sensor receives induction signal again,
it can work normally.
• When the sensor receives the second
induction signals within the first induction,
• Electrician or experienced human can install it.
• Can not be installed on the uneven and shaky surface
• In front of the sensor there shouldn’t be obstructive object affecting detection.
• Avoid installing it near the metal and glass which may affect the sensor.
• For your safety, please don’t open the case if you find hitch after installation.
• In order to avoid the unexpected damage of product, please add a safe device of current 6A
when installing microwave sensor, for example, fuse, safe tube etc.
• The load don’t work:
a. Check the power and the load.
b. Whether the indicator light is turned on after sensing? If yes, please check load.
c. If the indicator light is not on after sensing, please check if the working light corresponds to the
ambient light.
d. Please check if the working voltage corresponds to the power source.
• The sensitivity is poor:
a. Please check if in front of the sensor there shouldn’t be obstructive object that affect to receive
the signals.
b. Please check if the signal source is in the detection fields.
c. Please check the installation height.
• The sensor can’t shut automatically the load:
a. If there are continual signals in the detection fields.
b. If the time delay is set to the longest.
c. If the power corresponds to the instruction.
TEST
NOTES
SOME PROBLEM AND SOLVED WAY
Note: when testing in daylight, please turn LUX knob to
☼
(SUN) position, otherwise the
sensor lamp could not work!
it will restart to time from the moment.
• Turn LUX knob anti-clockwise on the minimum (3). If the ambient light is less than 3LUX (dark-
ness), the inductor load could work when it receives induction signal.
