WARNING
DESCRIPTION
ON / OFF FUNCTION
DIMMING (ADJUSTING BRIGHTNESS)
INSTALLATION INSTRUCTIONS
1. Please make sure to turn off the power before starting the installation.
2. Installation must be performed by a qualified electrician.
3. For indoor use only.
The product is a small controller with a capacitive sensor. It has two operating functions: on/off and dimming
(adjusting the brightness of LED lighting) within wide ranges (10%-100%).
By a single quick hand touch on the surface above the mounted sensor, the LED is turned on. By a second quick
hand touch on the same place, the LED lighting is turned off.
By a long hand-touch on the surface above the mounted sensor, the brightness of the LED lighting is increased
or decreased. By second long hand-touch, the brightness is adjusted at the opposite direction.
1. Clean the inside of the door thoroughly and install the controller here.(FIG 1)
2. Peel off the protective film from the adhesive sticker. (FIG 2)
3. Stick the dimming switch on the mounting surface(FIG 1)
4. Connect the OUTPUT connector to the load and the INPUT connector to the power
supply for te LED lights.
Note:
The dimming switch is intended exclusively for LED lighting. After a power loss and its restoration, the
switch remains in the off position.
NOTE
• Must be installed on the reverse side of the mounting surface.
• Surface thickness ≤ 25mm.
• Not suitable for installation behind mirrors or metal surfaces as it would not function.
Thickness: Max 25mm
FIG 1
FIG 2
Inside of the door
Dimmer
Touch Location
Controller
Outside of the door