User’s Manual of BTGP38 Bluetooth GPS Receiver V3.0 V-SUN Electronic Co., Ltd
III Operation Instruction
1. Load battery
Open the cover of battery door, and load the battery in right direction. Close the battery door..
2. Charge
Plug the AC end of the charger into main power supply socket. Plug the DC charger into the
hole on the product. Then, the red LED turns on, indicating it is charging. In about 2.5hr, red
LED turns off and the charger is completed.
Note: To maximize the lifetime of the battery, please charge it continuously for at least 10 hr for
the first time.
3. Set up wireless connection
Power on, the green LED turns on, indicating the state of location. Blue LED swiftly flashes,
indicating that it enters to matching state. Now, you input search command on your Bluetooth
device (computer, PDA, mobile or laptop etc). When it searches out, select “Vsun-GPS” and
then input the code“0000”, so that the matching is complete.
4. Test on computer
After the matching is completed, the computer will prompt that there is a serial port. Write
down the number of it and open the test software in the CD. Select the said port and set the bit
rate at 9600bps. Click “Open” to open the serial port and then it will display the current locating
data.
Serial port On/Off
Satellite distributing map Serial port number, Bit rate
Configure the serial port
Satellite locating data
Received satellite signal S/N NMEA data
IV Application
This product can send data relating to current location and movement information to the
navigation software of intelligent mobile or PDA through Bluetooth technology and assists the
navigation software to navigate and track. For detailed operation, please see the instruction
document of navigation software.
V-SUN Electronic Co., Ltd
WWW.V-SUN.CC
