V-Show S718 Elf, User Manual

Page: 15 / 15


Add a signal amplifier;

The signal line adopts high-quality shielded twisted pair;

Connect a signal terminating resistor (120 ohms) at the end of the fixture.
2. The lamps cannot be started

Check that the lamps have poor contact or fall off due to extrusion
deformation, vibration of internal parts, moisture and other reasons during
long-distance transportation.

Please check whether the wires and connectors inside the lamp are
detached or loose.

Check whether the electronic components of lamps (such as electronic
transformers, PCB boards, motor control boards, etc.) are loose,
short-circuited and burned out.
3. When working, the X-axis or Y-axis of the lamp does not move normally

Check whether the transmission belt corresponding to the X and Y axis
directions in the lamp is off and broken;

Check whether the data feedback receiver (optical coupler) corresponding
to the X and Y directions in the lamp is damaged;

Reboot to reset once.