Assembly
Note
4
68 M8 x 45mm CARRIAGE BOLTS . . . . . . 2
31
2
46 M10 x 125mm HEX BOLTS . . . . . . . . . 2
47 PLASTIC SPACER . . . . . . . . . . . . . . . . 2
48 M10 LOCKING KNOB (FEMALE) . . . . . .2
49 BUTTERFLY ARM BOLT BUSHINGS . . . 4
WEIGHT PLATE RETAINER CLIP . . . . . .
Slide a Butterfly Arm Pad Bar (45) into each Butterfly Arm (43) , now slide 1 x Foam Roller (40) onto each
Butterfly Arm Pad Bar (45).
Fit a Weight Support (14) to each Butterfly Arm using 1 x M8 x 45mm Carriage Bolt (68), 1 x M8 Flat
Washer (23) and 1 x M8 Nylon Locknut (26). Tighten securely and slide on the Weight Retainer Clip (31).
Fit 2 x Butterfly Arm Bolt Bushings (49) to each Upright - 1 each side of each Upright. Pass an M10 x
125mm Hex Bolt (46) through an M10 Flat Washer (25) and then through the front face of an assembled
Butterfly Arm. Slide on a Plastic Spacer (47) then fit the assembly to the appropriate Upright.
Secure the assembly in place with either: - 1 x M10 Flat Washer (25) and M10 Locking Knob (Female) (48).
Now fully tighten all nuts
and bolls.
23 M8 FLAT WASHERS . . . . . . . . . . . . . . 2
25 M10 FLAT WASHERS . . . . . . . . . . . . . 4
26 M8 NYLON LOCKNUTS . . . . . . . . . . . . 2
PART No. DESCRIPTION . . . . . . . . . . . . . . QTY
Assembly Accessories 4
Page
1
8
