GPS-VT 103 GPS Vehicle Tracker
8 / 13
Cancel: Send SMS “nospassword” to deactivate this function.
6.13.5 MOVEMENT ALARM
Set up: when the unit stays immobile in a place for 3-10 minutes, the user can send SMS
“move+password” to the tracker device. It will reply “move OK”. In case of such a movement (the
default distance is 200m), it will send SMS “Move” along with a Geo-info to the authorized numbers, it
will alarm in 3 minute interval.
Cancel: Send SMS “password” to deactivate the movement alarm.
6.13.6 OVERSPEED ALARM
Set up: Send SMS “speed+pspace+080” to the unit(suppose the speed is 80km/h),and it will
reply “speed OK!”.When the target moves exceeding 80km/h.the unit will send SMS
“speed+080!+Geo-info” to the authorized numbers. It will alarm one time in 3m interval.
Cancel: Send SMS “password” to deactivate the overspeed alarm.
Remark: It is recommended that the speed alarm is set at not less than 30km/h.For below that rate; it may
cause the excursion of the GPS signal influenced by clouds etc.
6.14 Cut off the Oil and Power System
Send SMS command “stop+password” to the tracker device, it will reply “Stop engine Succeed” to your
cell phone from the tracker device, and stop your car engine as well, at the same time. It will remain the
immobile state until receiving the next SMS command of resuming the oil and power once receiving
SMS command to cut off the oil and power system.
6.15 Resume the Oil and Power System
Send SMS command “password” to the unit, It will reply “Resume engine Succeed” and
resume your car engine as well, at the same time. It will remain this state until receiving the next SMS
command to cut off the oil and power system once receiving SMS command to resume the oil and gas
system.
6.16 Arm
6.16.1 Set up arm by SMS
Send SMS command “arm+password” to the tracker device in the vehicle. It will reply “Tracker is
activated” in both armed and disarmed state, and the SMS command will make the tracker device enter
into armed state if the unit currently disarmed.
User must stop the engine, (that is ACC is lower voltage).Sending SMS “arm+password” when close the
door and left. You will set up arm status fail if the engine is turned on (the ACC is high voltage), it will
reply “set up fail! pls turn off ACC”
6.16.2 Set up arm by remote control (Option, for model B ONLY)
Press “A” button on the remote control, the car enters into armed state and the siren will alarm one time,
no SMS reply.
6.17 Disarm
6.17.1 Disarm by SMS