UV Superstore LEOPARD UV Series, Installation, Operation And Maintenance Manual

Page: 11 / 48

ϱ
Electronic Control Center (ECC)
For Stainless Steel Enclosures
The ECC is designed to be remote mounted within 4-6 feet of the chamber. Prior to final
placement, ensure that the supplied cable lengths (8 ft.) are adequate to reach between the
ECC and the chamber.
The ECC requires clean power. Information on voltage and cycle will be on the wiring
diagram inside the ECC cover. Equipment should be kept off lines where there are surges or
brownouts. Always disconnect power before servicing the system.
The ECC will contain the ballasts and other electrical controls. For models equipped with the standard UV
Monitor option and/or standard High Heat option, the ECC will display operation status such as individual
Lamp Indicator, Elapsed Runtime Meter (ERTM), optional UV Monitor Intensity, optional Low UV Indicator,
and optional High Heat indicator. For models equipped with the optional WatchDog Monitoring System, the
ECC will display operation status such as individual Lamp Indicator, and the WatchDog Monitoring
System display is capable of monitoring total runtime hours, lamp runtime hours, lamp intensity, relative UV
percentage, temperature and in some models, real-time dosage.
The ECC is equipped with a manual on/off switch for standard models. The optional HOA (Hands Off Auto)
switch enables you to remotely power on/off your UV system.
Display Plate with
WatchDog Monitoring System
Option
Manual
On/Off
Switch
or
Optional
HOA
Switch
Elapsed
Run Time
Meter
Low
UV Indicator
High Heat
Shut Off
Indicator
Lamp Status
Indicator
Photo shown is display plate for
the standard UV Monitor Option
and standard High Heat Option
UV
Monitor
Option