UV Pure Technologies Crossfire Technology Hallett 1000NC, Instruction Manual

Page: 8 / 52

Hallett Instruction Manual
Released on 8-Aug-19
– GH2B
Page 8 UV Pure Technologies Inc. © 2019
CAUTION : Quartz sleeves are fragile
The quartz sleeve can break or chip if mishandled. Always handle it
with care and keep it in a safe place if it is removed from the unit. Do
not strike the quartz sleeve with any tool, since even the smallest chip
can cause it to break under pressure.
3. P
RODUCT
S
PECIFICATIONS
Specifications & Features common to all units
Operating Pressure
1
5-100 psig (34-690 kPa)
Water Temperature Range
2
34-104° F (1-40° C)
5
Air Temperature Range
2
34-104° F (1-40° C)
Maximum Relative Humidity
3
70%
Voltage Input 120 Vac 50/60Hz
Manifold materials 316 Stainless Steel
External Contact 2 available - Standard
Remote Start/Stop Standard
Data Logging to USB Drive Optional on all units
Automatic Solenoid Shutoff Valve Optional on all units
Wetted Parts
4
Meets NSF/ANSI 61 & NSF/ANSI 372
1
Purging requires pressure to work properly. The optional shutoff valve requires min.
10psig to operate.
2
An optional UV lamp heating kit is available for LPHO lamp systems to allow
continuous operation in low water and air temperatures.
3
For continuous flow potable applications, it is recommended to dehumidify the room
where the UV unit is located.
4
The Hallett 400NC does not meet NSF/ANSI 61 or 372
5
Certified by WQA to 73° F or 23° C
Flow restrictors are devices that limit the water flow through the UV unit
despite the demand or the amount of supply pressure. A flow restrictor is
mandatory for an NSF/ANSI 55 Class A system but optional for other units.
Warning: Removal of this device may allow the water flow to exceed the
validated performance of the system which therefore may not provide the
necessary UV dose to inactivate all pathogens.