UV3W-LED.docx
Page 11 of 17
© UV Light Technology Limited - Issue No: 3/12
Operating Instructions for UV 3W LED
3.
BATTERY FITTING
4.
OPERATION
Before switching on, always check the following. If in any doubt whatsoever do not switch on.
NEVER
operate
a)
If
there is any visible damage to the UV torch, battery charger, cables or
batteries.
b)
Without
the necessary control measures in place for protection against exceeding the
UV light exposure limit values.
4.1
Switching On
The operator should always point the UV light beam away from
their body and never shine directly at anyone’s unprotected skin
or eyes.
Switch on and off using the power switch on the rear of the
torch.
Once switched on it will reach it’s optimum output almost instantly.
Never put the UV torch down on the front glass when switched on.
The run time of the torch will depending upon the number of on/off switching cycles and the
capacity of the battery used.
Fully charged batteries will provide approximately 90 minutes of operation depending upon
the number of on/off switching cycles.
a) Unscrew and remove
the rear of the torch.
b) Insert battery -
positive terminal first.
c) Replace rear cover
