Operating and Maintenance
Your UV system is on continuously during normal use.
After periods of not using your water supply exceeding 2-3 days, it is
recommended to open all faucets and flush your plumbing lines for a
minute or two.
Caution:
Protect your unit from freezing. Drain all water from the unit
if freezing temperatures exist.
Ultraviolet lamp replacement:
The ultraviolet lamp located inside the
chamber will operate effectively, round the clock, for approximately
one year. The lamp will light longer than that. However, the UV light
penetration may fall below the prescribed safety level. Therefore,
annual lamp replacement is necessary regardless of apparent
condition.
Replacing the UV lamp and cleaning the quartz
sleeve
Note:
Do not touch the lamp or the quartz sleeve with your fingers.
Handle by ends only or wear soft gloves.
Ounplug
the system from the electrical outlet and turn off all water
supplies to the unit.
Ocarefully extract the lamp connector from the sleeve glandnut
assembly to expose just the top of the lamp. While holding the lamp
base firmly, remove the lamp power connector.
Caution:
lamp base
can be very hot - be careful not to drop lamp into quartz sleeve as it
easily broken.
� Carefully slide the UV lamp out of the quartz sleeve and discard
according to local regulations.
&Remove the quartz sleeve by loosening the glandnut and carefully
extracting it from unit.
Caution:
The quartz sleeve is fragile and is
easily chipped or broken - use care when removing or installing.
0c1ean the quartz sleeve with a vinegar solution or a readily
available scale removal product
(Limeaway, CLR etc.)
0Re-install the quartz sleeve - replace
·o·
ring if it appears
damaged.
&install new lamp by reversing procedure described in step 2 above.
0 Slowly open water supply valve and purge air from system - verify
that there are no leaks before reconnecting to AC power.
RESETTING THE LAMP CHANGE TIMER
0The lamp change reminder timer is reset by disconnecting the UV
power source from the AC supply, waiting for fifteen seconds and
reconnecting to the AC supply while depressing the timer button. The
UV power source will emit a solid three second beep indicating that
the reset was successful.
It is not possible to reset the lamp change timer unless the timer
is in the grace period or lamp change alarm mode. ff you need to
reset the lamp change timer prior to the full one year time period
expiring due to premature lamp failure, there are special
instructions included with all replacement lamps describing the
necessary procedure.
Product Specification
UVD320E
Rated Flow Rate
8gpm (30lpm) @ 40mj
10gpm (381pm) @ 30mj
AC Supply Voltage
120V 47-63Hz .7A
(240V 47-63Hz .35A)
Annual Lamp Chanoe Timer
ves
Lamp Change Grace Period
28 days maximum
Grace Period Audio Alarm Disable
yes (7dav increments)
Reactor Chamber Material
304
ss
Maximum Operating Pressure
100psi
Maximum Ambient Temperature
50C (122F\
Water Temperature Ranae
4- 37C (40 - 99F)
Lamp Service Life
9000hrs
Chamber Dimensions (L x D)
19" X 3.5"
Controller Dimensions (L x D x W)
7" X 1.7"
X
2.3"
Shipping Weight
?lbs
Inlet/Outlet Port Size
W MNPT inlet
%"FNPT outlet
REPLACEMENT PARTS
UV Lamp 400162
Quartz Sleeve 400161
"0" Ring Set 400202
UV Power Source 400236
Warranty
UV Dynamics water disinfection systems are supported wnh a 1ree from
defects' Workmanship and Material warranty as follows:
-A ten year pro-rated warranty on the stainless steel disinfection chamber
-A three year warranty on the UV power source
-A one year warranty on UV lamps, sleeves, and sensor
-Warranty commences from date of purchase. Proof of purchase required
UV Dynamics will repair or replace, at ns option, any defective parts covered by
the warranty. Shipping and handling are not included in this warranty. They will be
collected from you by your Dealer. Replacement parts pro\'ided under warranty will
be sent to your UV Dynamics dealer.
Parts repaired or replaced under the pro-rated warranty will be covered under
warranty to the end of the original warranty period. This warranty is also subject to
the condnions and iimnations outlined under the heading "General Condnions and
Limitations" below.
Warranty ror Replacement Lamps and Parts
UV Dynamics warrants replacement lamps, purchased for annual routine
maintenance and other parts purchased to repair product components that are no
longer covered by the original warranty, to be free from defects in material and
workmanship for a period of three (3) months from the date of purchase. During this
time, UV Dynamics will repair, or replace at its option, a defective replacement lamp
or part free of charge except for shipping and handling charges. The warranty
period on replacement lamps and parts wHI be verified using date codes and/or
purchase receipts. Your UV Dynamics Dealer will advise you on whether the
defective ttem needs to be returned to UV Dynamics for failure analysis.
General Conditions and Limitations
None of the above warranties cover damage caused by improper use or
maintenance, accidents, acts of God or minor scratches or imperfections that do not
materially impair the operation of the product. The warranties also do not cover
products that are not installed as outlined in the applicable OWne�s manual.
These limited warranties outline the exclusive remedy for all claims based on a
failure or defect in any of these products. They are in lieu of all other warranties
whether wmten, oral or implied or statutory.
Under no circumstance shall UV Dynamics have any liabilny for liquidated
damages for collateral, consequential or special damages or for loss of prorrts, or for
actual losses or for loss of production or progress of construction, regardless of the
cause of such damages or losses. In any event, UV Dynamics aggregate total
liability shall not exceed the specific product purchase price. The purchaser agrees
to indemnify and hold hannless UV Dynamics from all claims by third parties in
excess of these nmnations.
UV Dynamics does nol assume any liabilfy for personal injury or property
damage caused by the use or misuse of any of its products. UV Dynamics shall not
in any event be liable for special, incidental, indirect or consequential damages. UV
Dynamics liabilny shall, in all instances, be limited to replacement of the defective
product or part and this iiabiltty will Jerrninate upon expiration of the applicable
warranty period.
© COPYRIGHT 2011 • UVDynamics Inc. • All RIGHTS RESERVED
Provided as a courtesy to our customers
77 Centre St. N Huntsville, ON P1H 1T4 705-349-2837
