19
4. At the site selected for the FSU antenna, tentatively
mount the antenna and take several RSS
measurements approximately 15 cm from the
antenna. Position the antenna where it receives that
strongest signal. Then mount the antenna on a pole.
Refer to the figure below for assembly of the bracket
onto the pole
Weep Hole
Figure 2-4 : Antenna Mounted On Pole
Note :
Make sure that the weep hole is positioned at the lower edge of the
antenna bracket as shown in Figure 2-4.
5. After installing the antenna, use the PHS Signal
Analyzer to check the receiving signal level.
Measure the reception level (RX LVL) at the TNC
connector on the FSU. Target values are as
follows:
•
RX LVL: more than -78 dBm (35
dB
µ
V)
•
Frame Error Rate: less than 2%
Summary of Contents for UTS-600FSU
Page 1: ...Instruction Manual...
