2
TABLE OF CONTENTS
PRODUCT FEATURES & SPECIFICATIONS
SAFETY INFORMATION
Product Features & Specifications
.............................................................................................................. 2
Safety Information................................................................................................................................. 2 – 3
Installation Instructions ......................................................................................................................... 3 – 5
Operating Instructions........................................................................................................................... 5 – 6
Care and Maintenance ............................................................................................................................... 6
Troubleshooting
.......................................................................................................................................... 7
Warranty ..................................................................................................................................................... 8
PLEASE READ AND UNDERSTAND THIS ENTIRE MANUAL BEFORE ATTEMPTING TO ASSEMBLE, OPERATE
OR INSTALL THE PRODUCT.
WARNING:
•
Use copper wire only for supply connections. The wire
should be properly sized and insulated. Do not use
aluminum wire with this installation. Wires should be
suitable for at least 167°F (75°C).
•
Heater air flow must be directed parallel to, or away
from adjacent wall.
•
Observe wall, floor, and ceiling clearance
requirements.
•
All wiring must conform to national and local electrical
codes in the United States and the heater must be
grounded as a precaution against possible electrical
shock. Heater circuit must be protected with proper
fuses.
WARNING:
•
This heater is hot when in use. To avoid burns, do not
let bare skin touch hot surfaces. Keep combustible
materials, such as furniture, pillows, bedding, papers,
clothes, etc. and curtains at least 3 feet (0.9 m) from
the front of the heater and keep them away from the
sides and rear.
• Do not use outdoors.
•
This heater is not intended for use in bathrooms,
laundry areas and similar indoor locations.
• Extreme caution is necessary when any heater is
used by or near children or invalids and whenever the
heater is left operating and unattended.
IMPORTANT SAFETY FEATURES
*POWER INDICATOR LIGHT:
The power indicator light located above ON/OFF power switch on the control panel, lights when the heater is turned on
by pressing the power button.
**AUTOMATIC OVERHEAT PROTECTION – THERMAL CUTOUT:
This heater is equipped with a thermal cutout which will automatically shut off a unit if the grille is obstructed, or the
heater gets too hot for any reason. The heater will turn on when an abnormal temperature returns to normal. Should
the unit overheat and cause the thermal cutout to cycle, a cause of the overheating should be determined and
corrective action taken before further operation.
Digital Thermostat & 12-Hour Timer
Front Mounted Control Panel
Power Indicator Light*
Overheat Protection Sensor – Thermal Cutout**
Ceiling Mounting
Louvers & Variable Mounting Angle to Adjust Air Flow
Fan-Forced Heat Dispersion
Heavy Gauge Steel Body
Full Function Remote Control
FEATURES
Hard-Wired Installation
Three Heat Settings:
High – 6000W 240V 60Hz 1 Phase 24A
20,477 BTU/Hr
Med – 4500W 240V 60Hz 1 Phase 18.1A 15.358 BTU/Hr
Low – 3000W 240V 60Hz 1 Phase 11.9A 10.239 BTU/Hr
Fahrenheit or Celsius Display
Temperature Adjustable – Between 45°F (7°C) to 95°F (35°C).
ETL approved for sale in US and Canada
Conforms to OSHA and NEC when installed according to instructions
SPECIFICATIONS
