3
Lowes.com
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate, or install the
product.
WARNING
:
! " $ %
& ' * + *'
This product is intended for use with the enclosed gasket and with a junction box marked for use in
wet locations.
Turn the power off at the circuit breaker or fuse.
To avoid water damage and electrical shock, keep lamp holders 30° below horizontal. Keep lamps
at least 1 in. (2.5 cm) from the sensor (C). Do not allow the lamps to block the lens.
The light control requires 120-volts AC.
If you want to use Manual Mode, the control must be wired through a switch.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Assembly Time
: 30 minutes
Tools Required for Assembly (not included):
Silicone Weather Sealant, Flathead Screwdriver
PLANNING INSTALLATION
Range
Up to 70 ft. (21 m) (varies with surrounding temperature)
Sensing Angle
Up to 180°
Electrical Load
Up to 240 Watt maximum Tungsten (up to 120 Watt maximum each lamp
holder).
Power Requirements 120 V AC, 60 Hz
Operating Modes
TEST, AUTO, and MANUAL MODE
Time Delay
1, 5, 10 minutes
Range
Adjustable
1.
For easy installation, select an existing light operated
by a wall switch for replacement.
/ ; < =
(2.4 m) above the ground.
Note:
>
? < ' @ =
(2.4 m), aiming the sensor down will reduce
coverage distance.
Wall Mount
Eave Mount
1