UTICOR MI-17, Manual

Page: 15 / 20

If the monitor is equipped with a resistive touch screen, the CD comes with the driver software
for the touch screen.
When touched with a USB interface, the touch is powered by the PC.
The connection to the PC is made via a USB plug type A. The plug is located on the back of
the monitor.
A connecting cable of 3 meters is included.
To install the driver software, insert the CD-ROM into the drive.
Do not connect the USB cable to the PC.
Enter D: \ Setup.exe and confirm with OK.
Instructions on the screen.
For USB interface: DMC, TSC-10 Series, select USB.
The driver software is now installed.
After completing the installation, connect the USB cable to the PC.
The New Hardware Installation Wizard appears.
When asked, "Connect to the Internet"
- NO this time -
Select and select Next .
Click on "Install software automatically" and select Next.
When asking for verification - continue installation - select.
Select Finish .
Select Close .
The software and driver are now installed and the touch should be at fingertip
react.
Calibrate Touch Screen Now (Start, All Programs, UPDD, Calibrate)
ATTENTION: If a different touch driver is installed on the PC, remove it completely from the
PC before installation.
A not completely uninstalled driver can cause the touch does not work. If necessary, restart
PC after installation.
6 - Touch Screen
Seite 15