7
8
Figure 2
-
2
Install switch to the rack
This product’s fixing hangers are just to fix the switch rather than support
it. Use brackets under the device (fixed to the rack) to support switch
when install the switch to the rack
.
Instruction
2.3.2 Workbench Installation
2.3.3 Wall-hung Installation
You
also
can
put
the
product
on
clean
,
steady
vertical
wall
.
Installation
procedure is below:
(
1
)
Use
the
screws
to
fix
the
hangers
;
You can put this product on clean, stable, grounded workbench. The installation
procedure as below:
(
1
)
Carefully put the device upside down, clean the grooves on the chassis
backplane with soft cloth to make sure there is no oil or dust in it;
(
2
)
Remove the stickers on the foot pad, paste the foot pad in backplane groove;
(
3
)
Carefully put the device upright on the workbench.
Figure 2
-
4
Hangers installation diagram
Figure 2
-
5 Fix the switch on wall
(2
)
Drill
holes
on
the
strong
position
of
wall
and
then drive the rubber plug into
the hole;
(3
)
Drive these
screws
into the
hole for the rack and fix the product by aiming at
the rubber plug
.
Figure 2
-
3 Install
the second switch
The distance betweed the above switch and the below switch must be
greater than 5cm. if no distance, the cooling of the switch will be affected.
Instruction
Distance >5cm
(3) Put the device on the rack’s bracket and move the rack along the slot to
proper position
;
(4)
Use screws to fit the installation hanger at rack’s fixed slot, make sure the
device is installed at rack’s bracket steadily.
