81000-UTC
6. Turn the (right) Filling-Recycle Reverse Control knob to the Filling position.
7. After lift the vehicle up, turn on the power switch of the TOE, the cleaning solvent in now
injected into the transmission.
8. After injection, turn off the power switch then turn the (left) Fuel Pressure Recycle
Control knob to the Recycle position.
9. Turn the (right) Filling-Pressure Recycle Reverse Control knob to the Recycle position.
10. Start the engine to begin the cleaning process. This should take five minutes. During this
process, View the fluid flow through the View Flow tubes.
11. Turn the engine off after five minutes.
12. Begin the steps for the Oil Exchange Cycle (below).
Oil Exchange Cycle
1. Leave the Black Hose(return) and the Red Hose(pressure) connected as described in the
previous steps, but disconnect the hose to the TOE New Oil Input Hose Connector.
2. Review the vehicle manufacturer’s maintenance manual for the correct type and amount
of transmission fluid oil.
3. Remove the Oil Fill Cap on the top of the TOE and pour in the correct amount of new
transmission fluid oil. View the amount of fluid filling the TOE New Oil Tank Gauge.
4. Turn the (left) fuel Pressure Recycle Control knob to the Pressure position.
5. Turn the (right) Filling-Recycle Reverse Control knob to the Recycle position.
6. Turn on the power switch of the TOE begin the Oil Exchange. The pump pressure will
force the new oil into the transmission, start the engine while View the new oil flow in the
new oil window.
