NX-4V2 LED Keypad User Manual
9
station will cause the
cancel light
to come on. It will stay on until the central
station has received the cancel report.
Note: The cancel feature must be
enabled.
Bypassing zones
If you wish to bypass one or more zones, this must be done while the system is
in the disarmed state. The following steps are used for bypassing zones:
1. Press the [
BYPASS
] key.
2. Enter user code, if required (optional). The
bypass light
flashes.
3. Enter 1 or 2 digits indicating the zone you wish to bypass. (Example: Press
the [
1
] key for zone 1, press [
1
] - [
2
] for zone 12.)
4. Press the [
BYPASS
] key again.
5. The corresponding
zone light
will illuminate indicating the zone has been
bypassed. Repeat steps 3 and 4 for any other zone(s) that need to be
bypassed.
6. Press the [
BYPASS
] key again -or- press the [
#
] key to exit the Bypass Mode.
The
bypass light
will stop flashing upon exiting the Bypass Mode.
Group bypass
By pressing the [
BYPASS
] key, followed by the [
0
] [
0
] key, then the [
BYPASS
]
key again, all zones that are designated as group bypass zones will be
bypassed. Press the [
BYPASS
] key again to exit group bypassing.
Unbypassing
To manually unbypass zones, perform the bypassing procedure on a zone that is
already bypassed. The corresponding light for that zone will go off when
unbypassed.
Note: All zones will automatically be unbypassed each time the system is
disarmed.
Turning the door chime ON and OFF
The door chime feature must be enabled by your installer. The door chime is
turned on or off by pressing the
[CHIME]
key. If the chime is on, the chime light
will be illuminated. If the chime is off, the chime light will be off.
Each press of the
[CHIME]
key will toggle the chime feature on/off and produce a
momentary ding-dong sound.
