UTC Fire and Security interlogix AL-1191, Programming Manual, Page: 16 / 24

Smart Card Reader
Programming Manual
10
Protocol options
The reader supports different formats to transmit data.
To set the required protocol, do the following:
Table 3
describes the options.
2. Press
Menu
to toggle between the options. Press
Enter
to exit and save the displayed option.
1. From the display in
Figure 25
, enter
5
and
press
Enter
to access option 5.
The default display shows
Wiegand
(
Figure 26
).
Figure 25. Smart reader menu display
Figure 26. Wiegand display
Table 3. Protocol options
Protocol Description
Wiegand
All data is transmitted both online and offline in the Wiegand protocol. The information on the
card decides which format can be used (i.e. Aritech/Tecom ASP or Standard 26-bit format).
Mag stripe All data is transmitted both online and offline in the Track 2 Magnetic Stripe format. A
card present signal is available on the relay output (violet wire) if selected by configuration
card or option 8 (relay option).
Alliance smart card Not available at this time.
Smart Reader AL-1191/AL-1193
0-Exit, Menu:
Wiegand
*-Change, #-Exit