1-2
Product Overview
Section 1
Installation
Initial Inspections
Check the contents of the shipment for completeness and possible transport damage.
If the contents are incomplete or damaged, contact Utah Scientific Inc immediately for
repairing or replacement parts of the equipment.
Before Applying Power
Verify that the product is configured to match the available main power source per
the input power configuration instructions provided in this manual.
The modules of the UTAH 100-3 frame may only be installed in specific positions.
Interchanging power and function modules may harm the UTAH 100-3-frame
permanently.
The modules of the UTAH 100-3 frame shall always have the components facing
to the right. Failure may occur if modules are installed incorrectly.
Service
Servicing, adjustments, maintenance or repair of this product may be performed
by qualified personnel only. Adjustments described in this manual may be
performed with power supplied to the product while protective covers are
removed. Energy available at many points may, if contacted, result in personal
injury. Capacitors inside this product may still be charged even when
disconnected from their power source.
Summary of Contents for 100-3
