USSC Magnolia 2015, Owner'S Operation And Instruction Manual

Page: 6 / 24

6 Ussc
BLOWER ASSEMBLY
ASSEMBLY INSTRUCTIONS
THE BLOWER ASSEMBLY MUST BE DIS-
CONNECTED FROM THE SOURCE OF ELEC-
TRICAL SUPPLY BEFORE ATTEMPTING THE
INSTALLATION.
Step 1.
Fix the assembly to the back of the stove with
the four screws provided.
THE BLOWER ASSEMBLY IS INTENDED FOR
USE ONLY WITH A STOVE THAT IS MARKED
TO INDICATE SUCH USE.
DO NOT ROUTE THE SUPPLY CORD NEAR
OR ACROSS HOT SURFACES!
LEG ASSEMBLY
ASSEMBLY INSTRUCTIONS
The legs should come pre-assembled to the
stove. However, if you must replace a leg,
follow the instructions below.
The legs attachment hardware is either 2
nuts and 2 washers per leg or 2 bolts and
2 washers.
Prop the stove so as to remove the damaged
leg ensuring that the stove is sturdy enough to
perform the operation.
Re-install the leg as removed. Remove prop and
adjust the leg leveler.
If you are replacing/installing all legs, prop the
stove up from the side, under the bottom, be-
tween the legs. It should be raised high enough
to install the legs, approximately 11 inches.
Again, ensure the stove is sturdy enough to
perform this operation.