Note: The three cushioned pads installed between the
lid and the body of the unit are for shipping purposes
only. Please remove them.
STEP 2 SIDE TABLE ASSEMBLY & INITIAL FIRING
1. Attaching the Side Table
• Attach the side table to the main grill body
using the provided spacers, 1/4 - 20 X 3/4” bolts,
and washers. Note: The spacers are to be place
between the grill body and side table during
installation.
2. Bucket Placement
• Hang the grease catching bucket on the
provided hook located under the side table.
3. Initial Firing System Check
• Open the pellet hopper lid to check for foreign
objects in the hopper.
• Plug the grill into a three-wire, grounded wall
outlet.
• Press the power button to turn the unit on. DO
NOT TOUCH THE AUGER OR THE IGNITOR! Open
the hopper lid and check to see that the auger
is turning freely - approximately 2 rpm. LOOK
TO SEE THAT THE AUGER IS TURNING. DO NOT
TOUCH.
•
Place your fingers over the burn pot and feel
the air movement from the combustion blower.
Ignitor will glow within 1 minute.
• Press the power button to turn the unit off.
•
Clean the drip pans, flame plate, warming
grate, and grill grate with soap and water,
then rinse. Allow the components to dry before
continuing the assembly.
DO NOT TOUCH THE
IGNITOR OR THE AUGER.
IMPORTANT: DO NOT put any pellets into the hopper
or grill during the Initial Firing System Check.
Spacers
-6-
Summary of Contents for Cumberland
Page 15: ...Notes 15 ...
