USR-CANET200-User-Manual
Technical Support:
Jinan USR IOT Technology Limited
www.usriot.com
14
3.Parameter configuration
There are three ways to configure USR-CANET200. They are setup software, Web Server and AT command.
Note
: When user configures USR-CANET200 through network(Web Server, network AT command or setup
software by network), user should connect USR-CANET200 directly to PC or connect USR-CANET200 to same
router as PC(When user connects USR-CANET200 to same router as PC, user should configure USR-CANET200
into DHCP mode or change static IP into same network segment as router).
3.1.Setup software
We provide setup software for USR-CANET200 to configure by serial or network and when user uses setup
software, please close firewall and antivirus program.
3.2.Web Server
Web Server default parameters as follows:
Parameter
Default settings
Web Server IP address
192.168.0.7
Username
admin
Password
admin
Figure 14 Web server default parameters
After firstly connecting PC to CANET200, user can open browser and enter default IP 192.168.0.7 into address bar,
then log in username and password, user will enter Web Server. Web Server screenshot as follow:
Figure 15 Web Server
User can switch between Chinese/English by licking top right corner. If user changes Web page port, user should
enter IP address with colon and port number(such as 192.168.0.7:90).
3.3.AT command
We have specific user manual for AT commands.
3.3.1.Serial AT command mode
In work mode, user can enter AT command mode and send AT commands to module to configure the module. For
