Convert Server User Manual
Jinan USR IOT Technology Limited
11 / 41
Reload
Reload
Reload
Reload key:
key:
key:
key:
This key used for set up the Convert Server to factory setting, when Convert Server is working (Ready LED
on), press this key more than 1 seconds and free it, wait about 10 seconds until the Convert Server restart,
the green LEDs all off and then Ready LED on. Then the Convert Server goes to factory default settings.
4.
4.
4.
4. Application
Application
Application
Application
4.1.
4.1.
4.1.
4.1. Application
Application
Application
Application of
of
of
of AP
AP
AP
AP
As shown in figure in, Convert Server used as an AP, all the other Convert Servers and computer can be used
as the STA to connect this Convert Server, at the same time it also can through the UART or GPIO interface
to the user equipment.
4.2.
4.2.
4.2.
4.2. Application
Application
Application
Application of
of
of
of STA
STA
STA
STA
