6
Use for Professional Photography Lighting
Press the function button for a short time to start up and press the function key for two
seconds to shut down.
Click the function button in the power-on state to switch colours. The initial lighting
colours are as follows: white light, neutral light, warm light, red light, green light, blue
light, red and green lights, red and blue lights, green and blue lights, special effect
modes, white light and so on.
•
To brighten the light up, click the Brig button.
•
To dim the light down, click the Brightness
–
button.
When the light is off, the indicator light is yellow when charging and green when fully
charged. If the yellow light indicator light flashes slowly, it indicates that the power level
is at less than 30%. If the yellow light indicator flashes at a regular speed, it indicates
that the power level is between 30% to 70%. If the yellow indicator flashes quickly, it
indicates that the power level is above 70%.
When in use, the power indicator displays the power. The indicator shows a green light
when the power level is at more than 70%. The indicator shows yellow light when the
power level is between 40% and 70%. The indicator shows a red light when the power
level is between 10% and 40%. The indicator flashes red light when the power level is
less than 10%, which requires immediate charging.
Please do not turn on the light during recharging in order to protect the battery life.
Because of the charging, the internal temperature is increased, and if combined with the
light being turned on, the result might be shorter product life.
The natural discharge rate of lithium batteries releases 1% or less of their charge per
day when they are not in use. It is recommended that when it is not used for a long time,
the device is fully charged. Normally, it should be charged once in about three months.
Standard battery life varies between 2 to 32 hours (based on brightness used). Charging
takes between 3 to 4 hours when charged with 5V/2A adapter (not included).
To switch between the special effect modes, just press the “+” or “–“ button
in the special
effect modes to switch between the following effect modes:
Police car
Ambulance
car
Fire engine
Party 1
Party 2
HSI Fast
Gradient
Strobe