13
RELOADING A NEW ROLL OF FILM
ON A HOT LAMINATOR
Allow the old film to run to a point just before it pulls off the cardboard cores.
Turn the drive switch to “OFF.”
Cut the film web with a blade so that
approximately 5” of film extends beyond
the idler bar. Photo 14-1.
CAUTION: When using a sharp object to
cut film (blade or shears), avoid contact
with heat shoes or rubber rollers.
Remove the old cardboard cores and replace with new rolls of film. Photo 14-2.
Loosen the tension on the top film roll.
Thread the new web of film around the
idler bar and tape it to the remaining
segment of the expended roll.
Photo 14-3.
Repeat this procedure for the bottom
film roll. Use caution when threading film
near hot heat shoe .
Run film through the laminator until the
new web of film clears the pull rollers.
Photo 14-4.
Readjust tension.
Photo 14-1
Photo 14-2
Photo 14-3
Photo 14-4