Blutronium™ Serial Bluetooth Adapter – Datasheet & Quick Reference
www.USconverters.com
www.usconverters.com
Page 9
?
Inquire the current setting
NAME=
This command is used to specify a name for the adapter.
You can specify a friendly name using 0 to 9, A to Z, a to z, space and –, which are all valid
characters. Note that “first space or -, last space or – isn’t permitted”. The default name is
“Serial Adapter”.
(Default)
Serial
Adapter
Default device name
xx….xx
“xx….xx” is a character string with the length from 2 to 30.
R
Restore the default settings name=“Serial Adapter”.
?
Inquire the name of the local adapter.
PARITY=
This command is used to specify parity bit setting of COM port.
The command will need 200 ms delay.
(Default)
N
None parity bit
O
Odd parity
E
Even parity
?
Inquire the current setting.
PIN=
This command is used to specify a PIN. The default PIN is “1234”. Paired adapters should
have a same PIN. The length must be 4 – 16 alphanumeric characters.
Notice: this function currently only works with Windows versions prior to Windows 8.1
(Default)
1234
xx….xx
“xx….xx” is a
4 - 16 digit string of alphanumeric characters (in capital or lower case)
N
Cancel authentication by PIN.
R
Restore the default settings PIN=“1234”.
?
Inquire the current PIN.
PROMPT=
This command is used to decide whether status messages are prompted when Setup
commands are executed. The status messages are: OK/ERROR for command execution, or
CONNECT/DISCONNECT/Try Connect Device for connection status.
(Default)
Y
Prompt result messages.
N
Not prompt result messages.
?
Inquire the current setting.
RECONNEC
T=
The command is used to re-connect the lost link for the Master adapter.
?
Inquire the current setting.
(Default)
Y
Re-connect is disable
N
Re-connect is Enable
ROLE=
This command is used to specify whether the adapter is in the master or slave mode. If the
device mode is changed, the adapter will reboot and all paired addresses will be cleared. The
command is available when the adapter is in DIP=N status. The command will need 1 second
delay.
M
Set the adapter to the master mode.
(Default)
S
Set the adapter to the slave mode.
?
Inquire the current mode of the adapter.
RSSI=
Received signal strength indication
?
Display the Received signal strength indication in command mode when connected.
1. Strong: RSSI>-9
2. Medium: -9>RSSI>-20
3. Weak: RSSI<-20
SEARCH=
This command is used to search for any Bluetooth device in the neighborhood within one
