Page 2
CONVEYOR SERVICING INTERVALS
Every 40 hours or Weekly
1. Check the conveyor belt tension and alignment.
2. Grease conveyor bearings.
A. Two bolt flanged bearings, tail roller bearings right and left (2 locations).
B. Two bolt flanged bearings, drive roller bearings right and left (2 locations).
3. Remove guard and check the drive belt tension and alignment. The belts will
deflect approximately 1/4 to 1/2 inch when properly tensioned
.
Every 200 hours or Annually
1. Repack wheel bearings.
2. Wash machine.
3. Check pulley bushing for wear. To inspect pulley:
A. Lower the conveyor to its lowest position.
B. When the conveyor has reached the lowest position, it will stop at the pins.
C. Loosen and remove the bolt.
D. Inspect the bushing on the pulley for wear.
E. Reverse steps A-E for re-assembly.
