CAUTION:
PLEASE FOLLOW THIS INSTRUCTION MANUAL CAREFULLY TO
PREVENT ANY INJURIES OR COMPLICATIONS THAT MAY ARISE.
WARNING:
Before installing or maintaining the luminary, make sure all powers are
TURNED OFF
.
Verify that supply voltage is correct by comparing it with the label information on all
fixtures.
Make all connections in accordance with the NEC requirements, and make sure all
luminaries are properly secured to prevent any wire complications. This luminary is
to always be installed with the lens facing down and its not to exceed the maximum
ambient temperature rating noted on the specification sheet.
USSLxxxWPL
Series LED Area Light
Installation Sheet
LED DRIVER
V(-)
[BLACK]
V(+)
[RED]
TO LOAD
[LED BOARD]
[WHITE]
[BLACK]
ACN [BLUE/WHITE]
ACL [BROWN/BLACK]
GROUND [GREEN]
NEUTRAL [WHITE]
GROUND [GREEN]
HOT [BLACK]
INPUT
OUTPUT
DIM
WHITE (-)
BL
UE(+)
Inside F2SB
PRE-CONNECTED
(DO NOT DISCONNECT)
Using a J-Box (not included), Connect the ACL and the ACN from the driver to the conduit with the AC Power Supply cords.Follow the Wiring Diagram provided.
* LED DRIVER Input Ground (green) wire only available for selected fixtures.
If the Ground Wire is missing and the Power Supply includes a ground wire, connect the power supply ground wire to the fixture.
(FOR DIMMABLE VERSION)
ARM MOUNT (SQUARE POLE)
7. Adjust the Tilt Angle on the
luminaire,
once the Tilt Angle is as
desired, finish
tightening the Socket
Head bolt to firmly
tighten the
fixture
with
the Arm Mount.
STANDARD INSTALLATION STEPS
DRILLING TEMPLATE
5.50 in
4.25 in
3.6875 in
.625 in
1.
Use provided Hole Pattern for drilling. Make sure to make
an extra notch for the power cables to run through the
Square
Tube.
2.
Place mount against
square
tube.
3.
Install the provided [2] Socket head
M8-1.25 x 40 mm bolts with lock washer
and washer to secure the arm mount
firmly in place, insert the flat-bar
with threaded holes inside the
round tube and use the
threaded holes to secure
the mount. Make sure all
bolts are tightened and
holes are properly sealed.
4. Once the Arm Mount is properly
fastened to the mounting round pole, run
the power cord cable from the inside of
the pole and out the notch from the
Arm Mount. This cable
will then be inserted into
the fixture.
5.
Run the power cord from the
arm
mount to the luminaire,
Once the
cable has been inserted
inside the
fixture
, connect the power
cable to
the LED Driver inside the
fixture
. In
order to access the LED
Driver
cables, the electrician must
first
remove the [6] screws from the
service door using a #2 Phillips
screw driver and make all
connections inside the luminaire.
6.
Once all wiring is complete,
Close the service door and use
the
M12 bolt to fasten the
Arm Mount to the
fixture
.
Do not fasten completely.
