USASPEC BT35-HON, Owner'S Manual

Page: 4 / 11

Installation
It is recommended that the BT35 be installed by qualified professionals.
When installing the BT35, beware of sharp edges and exercise caution
when removing panels and trim as they may break. Please review the
manual while installing and pairing the BT35 to ensure that it functions
properly.
Cable Connection
1. Make sure DIP switches are still in their default settings: all OFF.
2. Remove all CDs from the in-dash CD player/changer
before disconnecting the radio.
3. Carefully remove the radio from the dashboard.
4. Connect the CAS-H35 to the 14-pin connector
in the back of your radio. (If your radio has a
factory XM receiver already connected,
disconnect the receiver and plug it into the
CAS-H35.)
5. Connect the CAS-H35 cable to the
BT35 in the box labeled “RADIO”.
6. Connect MIC35 to the BT35.
7. Turn on the radio and test to see if your
Bluetooth device works with the radio.
(Refer to the Pairing Section on Page 4)
8. Install the BT35 into an easily accessible area.
9. Install the microphone in an area that
will not obscure the voice projection.
10. Reinstall the radio into the dashboard.
MINI-USB is for factory use only.
Please do not attempt to connect
any devices to the mini-USB port.
DIP Switch Setting
The DIP switches on the BT35-HON should all remain on the factory
default settings: all switches on the OFF position.
Device Compatibility
rd th
Most Bluetooth devices (such as iPhone3G/3Gs/4/4Gs, iPod Touch 3 /4
generations and Android phones) are compatible with the BT35; however,
USA SPEC does not guarantee that all Bluetooth devices are compatible. For
a current list of the compatible devices, please refer to our website
www.usaspec.com.
3
Recommended Microphone Placement