7
WIRELESS REMOTE CONTROL
1. Twist open the remote control’s bottom cap
2. Remove the battery’s protective film
3. Close the cap
4. Use the enclosed double-side tape to place the remote
control at a location that is most convenient for you.
Please avoid placing it over or around any airbags, or
under direct sunlight.
Remote Control Low Battery Indicator
1. The LED on the remote control will blink 10 times to
indicate that battery is low. Please replace it with a 3V
CR2032 battery.
2. Turn vehicle’s ignition OFF
3. Twist the remote control’s bottom cap off and remove the
battery from its housing
4. Turn vehicle’s ignition ON and
within 60sec
insert the
replacement battery in the housing.
5. You will hear a long beep through your radio (make sure
it is in AUX mode) at the same time the remote control’s
LED will turn solid blue followed by 10 flashes.
6. If you do not see it flash 10 times then repeat Step 2-5.
• If your remote control is not functioning properly upon
initial setup then please perform step 2-6
