5
Quick Start
10. SET STEAM CONTROL VALVE
to control the
amount of steam pressure.
Ø
Turn the dial counter-clockwise (toward the “+” sign
on the dial), the steam will increase.
Ø
To reduce amount of steam used, turn dial clockwise
(toward the “–“ sign on the dial).
Ø
Do not turn the dial all the way clockwise.
This is the lowest possible setting and no steam will come out when you press the steam trigger.
11. PRESS STEAM TRIGGER:
Now “bleed” the hose of water by squeezing the
hose trigger
to
shoot excess water from the hose into a towel for about 10 seconds.
REFILLING YOUR STEAMER:
When one of the following happens, your steam cleaner is low on water:
Ø
The orange Low Water Indicator Light turns on.
Ø
The pressure drops fast (below 2 bars) and pressure
gauge stays low.
Ø
Amount of steam is very light and moisture content is
low.
How to refill your steamer:
1.
Press the
power button
to the
OFF
position.
2.
Leave
Steam Release Button
“on”
3.
Pull the
spray trigger
handle until pressure gauge reads ”0” (zero).
Push Turn Power to Off
Leave “Steam Release” in the “On” Position
4.
WARNING - DO NOT ATTEMPT TO ADD WATER WHILE THE BOILER TANK IS STILL
HOT. LET THE STEAM BOILER COOL AT LEAST 15 MINUTES BEFORE ADDING
WATER.
5.
Cover the safety cap with a towel, press down on cap and turn cap very slowly counter-
clockwise. You may hear some steam escaping.
Ø
Keep the towel over the cap.
Ø
Remove the safety cap.
6.
Replace safety cap and hand tighten the cap turning clockwise.
Ø
Plug the steam cleaner in and press the On/Of (the orange light on the button should
illuminate).
Low Water Light
WARNING: THE DIAL ON THE
PRESSURE GAUGE MUST READ ZERO
BEFORE REMOVING THE SAFETY CAP.
REMOVING THE SAFETY CAP UNDER
PRESSURE CAN RESULT IN SERIOUS
INJURY
