4
QUICK START GUIDE
1.
FILL TANK WITH WATER:
Remove the cap and pour tap
water into the steamer. DO NOT put cleaning fluids in the steamer.
2. PLUG IN THE STEAM CLEANER:
Plug the power cord
into
an 110V outlet. The steam cleaner should be the only appliance
plugged into an outlet.
Use only a 15AMP extension cord with maximum length of 25ft.
3. CONNECT HOSE TO STEAM CLEANER
:
Lift socket
cover
on the front of the steam
cleaner and attach hose. Lower socket cover inserting retaining pin into hole on top of hose.
Lift Socket Cover Lower socket cover inserting retaining
pin into hole on top of hose
4.
POWER ON THE STEAM CLEANER:
Press the
POWER
button
to heat the water in the boiler. It will take
9 minutes before your
steamer is ready to use
.
Power Button
5. BLEED THE HOSE BEFORE USING:
Squeeze the trigger to shoot excess water from the
hose into a towel for about 10 seconds.
6.
STEAM CONTROL DIAL
is to control the amount of steam released.
By turning the dial counter-clockwise, the steam will increase. To reduce
amount of steam, turn dial clockwise. Do not turn the dial all the way
clockwise. This is the lowest possible setting and no steam will come out
when you pull the steam trigger.
7.
REFILLING THE STEAMER
:
When the steamer is low on water, the
orange low water light will start blinking and steamer will beep. Remove
cap and add water.
During start-up, the holding tank may run low on water
causing the low-water light to blink and the steamer to
beep ADD WATER
