VT-X5
The USFT VT-X5 Install Guide
Installation and
W
iring
Step 3 > Status LED Lights
USFleetTracking
405.726.9900 | 2912 NW 156th Street | Edmond, Oklahoma 73013 |
usft.com
If you have any questions or encounter any difficulties with this system, please contact our technical support.
Monday through Friday 7 a.m. to 7 p.m. CST and Saturday 9 a.m. to 4 p.m. CST
■
1 blink - the modem is not detecting a SIM card.
■
2 blinks - the modem is not detecting a cellular signal. Check antenna connection.
■
3 blinks - the GPS receiver is not tracking any satellites. Check antenna connection and placement.
■
4 blinks - the modem has no cellular signal and GPS is not tracking any satellites.
■
5 blinks - the modem is not detecting a SIM card and GPS is not tracking any satellites.
■
6 blinks - the modem is not responding, and the antenna may be disconnected or the device may
be incorrectly configured within the firmware.
■
7 blinks - the modem is not responding and the antenna may be disconnected and GPS is not
tracking any satellites.
■
8 blinks - GPS is okay, but the modem is not registered on a network. A problem with the cellular
account is possible.
■
9 blinks - the modem is working correctly, and GPS is tracking satellites but is not making position
fixes. The device or antenna may need repositioning for a good view of the sky.
Blinking LED lights will signal the following:
The
long red
wire (power) should be directly wired to a constant 8V - 16V power source found at the
key source or fuse panel.
The
long black
wire (ground) should be securely fastened to a grounded screw or to chasis ground.
The
long white
wire (ignition) is the ignition event wire that is best installed directly to the ignition
wire. Ensure that power to the ignition wire is available ONLY when the vehicle ignition is turned on.
All makes and models of vehicles are different - we recommend you make sure that you know your
particular vehicle’s Constant and Ignition wires and their specific color(s) prior to installation.
The
white
,
blue
,
red
/
white
,
grey
and
green
/
yellow
wires (input) can be used to monitor many
functions such as PTO activity (Power Take Off), emergency lights, panic switch, etc.
The
green
,
white
/
brown
,
yellow
and
orange
wires (output) can be used to lock/unlock doors, honk
horn, remote start or disable starter, etc.
The
red
bundle wires are to be connected to a 12V backup battery.
*
Must be connected for device to work properly.
Power
Ground
Ignition input
8-16 VDC constant
Ground
Key (on)
*
*
*
Long Red
wire
Long Black
wire
Long White
wire
Green
/
Yellow
wire
White
wire
Blue
wire
Red
/
White
wire
Grey
wire
PTO 1 (12V)
PTO 2/Panic
PTO 3 (12V)
PTO 3 (12V)
PTO 4
Switch 1 Input (-)
Switch 2 Input (-)
Switch 3 Input (-)
Switch 4 Input (-)
Input - Bias high
Backup Battery
Horn
Unlock Door
Remote/Start
Starter Kill/Lock
Red
bundle
White
/
Brown
wire
Yellow
wire
Green
wire
Orange
wire
Input (12V)
Relay 1 Output (-)
Relay 2 Output (-)
Relay 3 Output (-)
Relay 4 Output (-)