EC35 Assembly and Timing Instructions
Please Note:
The EC35 is designed for one-time installation.
Local: 360.260.2468
▪
Sales: 800.736.0194
Support: 360.397.9999
▪
Fax: 360.260.2469
1400 NE 136
th
Ave.
▪
Vancouver, Washington
▪
98684
▪
USA
8.0
Page 1
Step 1
:
Slip base and then centering tool over the shaft. Press
down on the centering tool to secure the base in an aligned
position on the mounting/motor surface and tighten the two
mounting screws. Remove the centering tool.
Step 2
:
Energize the U phase motor winding with a positive DC
voltage (relative to V or W) to lock the motor into position.
Step 3:
Align assembled encoder over the motor shaft so that the
mark on the hub is oriented in the desired direction for
cable exit; this aligns the encoder’s index and U signals to
the motor’s U winding. Note: the index marking on the disk
is located ~180 deg. from the hub marking. Press the
encoder onto the shaft until it snaps down on the previously
mounted base. Press firmly near the cover through hole to
ensure that the encoder gap is set.
Caution:
Do not press
directly on the connector to avoid damaging the connector
shroud.
Step
4
:
De-energize the U phase motor winding
.
