III. CALIBRATION
This scale is pre-calibrated at the factory. Only re-calibrate if you are experiencing trouble weighing.
1. Turn on the scale.
2. Press and hold the [M] key until LCD display “CAL”, release the [M] key.
3. Press [M] key again, Now the display reads “CAL” and “500.0g”.
4. place a 500g cal-weight on the center of the platform, wait 3 seconds, LCD display reads “PASS”,
then return to the normal weighing mode.
Calibration is complete! You can turn off the scale.
PLEASE CHECK AVAILABILITY OF WEIGHTS WITH THE STORE YOU BOUGHT THE SCALE
FROM. .
IV SPECIFICATIONS
Capacity:500g/21.16oz/19.29ozt/385.8dwt
Readability:0.1g/0.01oz/0.01ozt/0.1dwt
Units: g/oz/ozt/dwt
Tare Range: Tare full capacity
Auto Off: 60 seconds off
Operation temp: 50 to 86 degree F
Display: LCD 5 ½ digits
Power: 2 x AAA batteries
Dimensions: 4” x 2.5” x .75”
V. TROUBLESHOOTING
The primary reasons for inaccuracy or malfunction are low batteries, incorrect calibration, overload or
operating on an unstable surface. Please keep this in mind and maintain and operate your scale properly.
This scale is a precise instrument and must be handled with the utmost care and caution.
[Display] Elimination of errors
[Lo]
Change the batteries.
[OUE2]
Recalibrate the scale as shown above.
[EEEEE]
You are overloading the scale. Remove the excessive load immediately!
[UnST]
Use the scale in a more stable position
