Hold the tool’s switch handle and the aux-
iliary handle firmly with both hands during
installation. Hold in the auxiliary handle in
position and aim at hole in the gear box. In-
stall the bolts and tighten them with the hex
wrench. The auxiliary handle can be installed
in two different directions; whichever is con-
venient for your work (left & right).
FITTING POLISHING DISC AND WOOLEN PAD
CAUTION: Always be sure that the tool is
switched off and unplugged before adjust-
ing or checking function on the tool.
Press the spindle lock
button (1) to prevent
spindle (2) rotation
when installing or
removing accessories.
Place the polish-
ing plate (3) on the
spindle and rotate
clockwise, then press
the spindle lock but-
ton firmly so that the
spindle cannot revolve, then with spanner (4)
tighten clockwise the polishing disc.
Install the wool bonet (5) by simply put the
woolen pad over the polishing disc. Let it op-
erate for more than three minutes for check-
ing it up without load.
OPERATION INSTRUCTIONS
BEFORE START OPERATION
SHAFT LOCK
CAUTION: Always be sure that the tool is
switched off and unplugged before adjust-
ing or checking function on the tool.
CAUTION: Never actuate the shaft lock
when the spindle is moving. The tool may
be damaged. Press the shaft lock to prevent
spindle rotation when installing or removing
accessories.
SWITCH ACTION
To start the tool, press the safety switch (wich
avoids unintentional starting) this makes you
activate the ON/OFF switch allowing the user
to operate the polisher.
To stop the tool simply release the ON/OFF
switch.
SPEED ADJUSTING DIAL
The tool speed can be changed by turning
the speed adjusting dial to a given number
of stops from 600 to 3000 RPM.
CAUTION: If the tool is operated continu-
ously at low speeds for a long time, the mo-
tor will get overloaded, resulting in tool
malfunction. The speed adjusting dial can be
turned only as far as 3000 and back to 600.
Higher speed is obtained
when the dial is turned
in the direction of num-
ber 6.
And lower speed is ob-
tained when it is turned
in the direction of num-
ber 1.
OPERATION
CAUTION: Always wear safety glasses or a
face shield during operation.
Hold the tool firmly. Turn the tool on and
then apply the wool bonnet to the work-
piece.
In general, keep the
wool bonnet at an
angle of about 15
degrees to the work-
piece surface. Apply
slight pressure only.
Excessive pressure will result in poor perfor-
mance and premature wear to wool bonnet.
MAINTENANCE
BEFORE ALL CARE AND MAINTENANCE WORK
• Turn the machine off.
• Wait until the machine has come to a com-
plete standstill.
• Pull out the power plug.
How to change the
woolen pad
3
2
4
5
1
15˚
10
LP607A manual.indd 10
26/01/16 10:18 a.m.
